Результаты поиска

I have the exact same problem, otherwise everything works, but it is a bit annoying

Thank you very much, i haven't seen that, will try and report back , once again thanks, i really appreciate your help UPDATE: Today managed to hook up my fathers car, the Renault scenic II, and in 1 minute I have managed to change the dash language, so it is working as expected. Thanks a lot...

thanks, but in the description it says that this vehicle is not supposed, can i still do it ?

you are changing how? or you want to change?

Hi all, is there a way to change the dash language from french to English on this car? Any ideas?

You are absolutely right, while searching for a st link, i have discovered that even the clones come with fake chips, ( the clones have clones) because the chip used is not even STM32F1, but something else, thats why i said in my previous posts " the ones with genuine chip and with fake chip"...

I wanna apologize, i should have made myself clear in the beginning that i have the small usb flash drive like st link v2 adapter like this: https://a.aliexpress.com/_mqLCJss I have ordered 2 more, one with genuine chip and one with Geehy chip on it just to test and be sure that mine is not...

i was hoping that this is the problem as well, but when i opened my st-link all the pinout corresponds to the case, so no luck there :(

Do you mean pin 1 on st link which is RST, the instructions says that Reset from board should go to pin 5 which is not a RST on stlink! So you suggest that i connect reset from board to pin 1 then supply additional 12V to pin 4 on mucar and 16 on OBD ? What about the 3.3V still supply them as...

is your st-link with genuine STM chip or another type? Did you open it to see?

I think mine is also a brand of Mucar BT200

H all, i have been trying to flash my dongle with diagzone firmware but i can not connect it to the computer, when i press connect on ST Link Utility it says can not connect to target. I have followed the st link instructions for connecting the diagram as stated but still no luck, my st-link v2...